Forum

[Jim]

I say chaps, could some kind person post a picture of our host's aftermarket rear wheel adjusters for the EFI please? I'm just wondering (given the difficulty in fitting them) if I ordered the wrong ones. at £27 a pair I can't afford to by another set just to find out. [/b][/b][/b] Ta

[Chris [Stockport]]

Just had a look in the ACCESSORY SHOP (top left of Hitchcocks list)........ Then go to FRAME/CHASSIS.... and then to TYRES AND WHEELS. Found something there, with picture. Seems to fit a lot of models. Hope that helps. Sorry I can't put a picture on here myself. But maybe give that a try? Good luck, Chris

[Exile]

Here you go..

[Leon Novello]

It is strange, most locknuts that I have encountered over many years, require a slimmer spanner than normal to hold the lower nut, causing great anquish as I had to grind down the face of the spanner to make it fit. Why is it so? One shouldn`t have to buy a special thin spanner which is usually hard to find in most stores anyway.

[Norm]

Sometimes life is tough Leon

[Mudplugger]

Engage brain and put the thinner nut on top!!

[Leon Novello]

Hi Mud. The nuts are usually the same thickness and a lot of the machinery I worked on (or ) on which I worked, used an acorn nut for aesthetic purposes. I understand your concern for my sanity but it hasn`t been through as much strain as Norm`s and he seems to be managing.

[Norm]

Leon, my life is moving forward now, I pulled down my last Bullet motor on Wednesday, it had broken a rod at 25,000ks, cases didn't look too bad from the outside, but the oil tank section inside was all smashed, cases went in the scrap bin and I told the owner to go and fit a diesel in it, so now I can look to a brighter future lol

[Jim]

Gentlemen (and others) Thanks for the raplies and thanks for the picture Lean. They seem to be the same as I have but they never seem to sit correctly at the back of the swinging arm. The catalogue gives a different part number for the EFI adjusters but no pictures.

[Jim]

That should (of course) read "Thanks for the replies" and my apologies Leon for spelling your name wrong. we need an edit facility on these posts.