Forum

[stinkwheel]

I was getting fed up of my toolbox lids on my bullets marking the paint by resting against the head of the big nut holding the lower rear mudguard rail on when open. I've come up with a neat solution which was to buy a set of black silicone car wheel nut covers for 21mm nuts. They just slip over and look neat as you like. I suspect they would come off fairly easily but I just secured them in place with a small dab of plumbers silicone which will pull off when required.



They also fit over the end of various exposed chassis bolts and the ends of the swingarm pivot.

[mauri]

our host have these also in various sizes

[Leon Novello]

Good thinking. The covers on my Bullet`s toolbox never swung down that far.