- Sun Jul 22, 2018 7:04 pm
#8670
On my 1993 bullet one of the timing cover screws doesn't have a wavy washer but a fiber one. I've high-lighted it in the picture.
I have a full gasket set but there isn't one small enough in the kit. Is it correct that you use a fiber washer in this location?

Also item 7, the drain feed plug aluminium washer; There are aluminium washers in the gasket set but none even close to the right size.
I have a full gasket set but there isn't one small enough in the kit. Is it correct that you use a fiber washer in this location?

Also item 7, the drain feed plug aluminium washer; There are aluminium washers in the gasket set but none even close to the right size.
