Forum

[sofiaspin]

Hi all - been a while since I posted but I have just acquired a new Euro 4 Classic - the one with twin discs and ABS. I cannot fathom out how to adjust the lean angle of the brake pedal. Currently it stands proud of the footrest and I need to lower it. I tried adjusting the plunger bolt on the hydraulic brake but the pedal just wobbled around. Is there a solution? Bring back a rod and drum brake!

[Andy M]

Back off the lock nut and move the yoke on the cylinder a turn or two? Its your basic rear disc setup every decent jap bike has had since 1980. If the yoke adjustment isn't enough something is in the wrong place which I find entirely believable. Slacken off the bolts as you would for an oil change and slide the whole cylinder to the rear if you can? Run a tap down the cylinder rod to give more adjustment?

Andy

[sofiaspin]

Much obliged thank you from a carb and drum member.