Forum

[papasmurf]

Is it just me or is it impossible to repack the tools in a motorcycle tool roll, and put it back where it is carried on the bike.
I gave up on my wife's Suzuki Intruder, and I have made the mistake of taking all the tools out on the tool roll on my Electra X (ish).
I doubt if I will be able to put that back either.

[Mark M]

But they're not for actually using! The new bikes I've had were mostly supplied with crap tools as standard, I think the only thing that worked in any of them was the spark plug spanner. And the Suzuki Bandit didn't even have that as the plugs are so far down a tunnel in the liquid cooled cylinder head it would have to be a foot long. The toolkit on the current BMW is actually good quality but still needs supplementing with better quality Allen keys for instance. On the Enfields (Redditch) we're a bit luckier than many other British makes, for routine maintenance including wheel removal you only need a small number of spanners.

REgards, Mark

[papasmurf]

Many years ago my wife had a 250cc Cossack Motorcycle,(from new.)

It developed a gear box fault (when out of guarantee.) I was able to strip the gearbox with the tool kit provided, (and repack the tools and fit them back on the bike.)
Plus the gearbox was repaired with a bit a clock spring to replace the flat spring that had broken.

[Rattlebattle]

Yes, I still have the toolkit that came with a Lada I owned back in the eighties. It even included an inspection lamp. BMW tools may be good but you don't get many these days - how about an Allen key to remove a panel. Same with my Triumph - one Allen key to remove the seat. To answer the OP - yes, it's you, you haven't got the knack or have added some tools.....

[papasmurf]

Rattlebattle, no extra tools involved. I suspect it takes a child working in a foreign sweat shop to do the original packing.

[Andy M]

OE tools go in the box of stuff to be saved until I sell the bike. I make my own tool rolls to take the higher quality, correct sized stuff. The UCE tools are a worse joke than usual, they include such rubbish as 3 inch long tyre levers when the TL Avons need a bead breaker. They seem to be tools for an older bike.

Andy

[papasmurf]

Andy M, they seem to be tools made for use by someone with the strength of an Orang-Utan or a Gorilla.

[Scalyback]

[center]


Well, I only have the usual small space in the toolbox for the toolroll, but it does contain:-


Large and small Lucas girder adj. spanners

Tecalemit grease gun

5 spanners (4 Whitworth and 1 septic)

stick pressure gauge



Champion spark plug feelers and bender

Strange looking Enfield spanner

'nother strange looking Enfield spanner

set of 3 nesting box spanners (6 whit sizes) and bar

Spark plug spanner

2 Enfield tyre levers

Enfield screwdriver.

It always rolls up a treat `and goes straight in the space for it!












[center]

REOC 15084

Tabellarius de verbis. Ostensor gaudium[/center]

[Eezzee]

As Rattlebattle said, on a modern Bonneville you only get one Allen key, for removing the seat, but the real beauty of that is that its kept behind a side panel, which is held on by a screw. If the screws is too tight to remove with a coin you need a screwdriver (not supplied) and of course you only know about the existence of this Allen key after reading the owners manual, which is kept in a pocket under the seat, which you need the Allen key to remove.....

[PeteF]

I once tried to use the tyre levers that came with my Bullet. Looked like Uri Geller's workshop.