More 535 Thoughts. - Page 4 - Hitchcocks Forum

Reply

More 535 Thoughts.#72504

By Tomshayes - Mon Nov 27, 2017 9:16 am

- Mon Nov 27, 2017 9:16 am #72504

Gearbox in frame and new rearsets fitted.... It's a start....

Tom

More 535 Thoughts.#72524

By Alan R - Tue Nov 28, 2017 12:48 am

- Tue Nov 28, 2017 12:48 am #72524

Hi guys------- I show this Honda XBR500 con-rod /big end assy and Tech. Spech. just for interest's sake....... https://www.ultimatespecs.com/motorcycl ... r-500-1988 ...................

More 535 Thoughts.#72529

By Tomshayes - Tue Nov 28, 2017 10:27 am

- Tue Nov 28, 2017 10:27 am #72529

I'm going for the Roller bearing and steel conrod option..

More 535 Thoughts.#72609

By Tomshayes - Sat Dec 02, 2017 4:26 pm

- Sat Dec 02, 2017 4:26 pm #72609

picture hosting

Looks like I've got to cut a channel to allow clearance for the 5 speeders rearset to operate.. I like the look of the original Clubman S so I'm keeping the tool boxes... Plus they come in handy....

More 535 Thoughts.#72610

By Tomshayes - Sat Dec 02, 2017 4:47 pm

- Sat Dec 02, 2017 4:47 pm #72610

More 535 Thoughts.#72612

By Alan R - Sat Dec 02, 2017 7:11 pm

- Sat Dec 02, 2017 7:11 pm #72612

Hi Tom-------- cutting into the toolbox is going to be a bit drastic I would have thought ?-------From looking at your photos it seems like you could re-drill the clevis pin hole a wee bit lower, maybe an inch ??......That should give the needed clearance for the linkage rodding...........Also, as you are now going to fit the roller big-end you might want to consider our hosts uprated oil pump conversion...... This is to increase the flow-rate NOT the pressure.....Good luck and keep "The Faith" !!