Forum

[stefaand]

I finaly got my gearbox welded and was ready to put it all together, when I did this while hammering the layshaft bearing in..
in other news I did get the bearing in.. back to the welder it is

[PeteF]

Clumsy!
You might have done better to press the bearing in.

[papasmurf]

Suitable music for such incidents as you curl up in a corner of the workshop/garage and cry:-

https://www.youtube.com/watch?v=JJLIsTkj3XE

[Scalyback]

[center]


"You were only supposed to blow the bloody doors off!"

[Mark M]

No hammering required! Heat case until bush comes out with a light tap then insert frozen bush using layshaft as a mandrel. Simples! REgards, Mark

[stefaand]

Sadly I dont have a bearing press, just some wood and a hammer I froze the bearing to death, but george the hairdryer failed me, so I had no choice but to use my fancy Jeremy Clarkson gear. I was soo looking forward to putting the gearbox back together..

[stefaand]

@ papasmurf.. I went for something less dramatic: https://www.youtube.com/watch?v=-CGIii_eTOk

[Norm]

Welding that up is the least of your problems, it is the threads for the detent plunger that are going to cause you problems. Hammer should have been nowhere the casing, use a longer piece of wood

[Scalyback]

Hey Steffand, is that '@' o ne of those twitter things?



Hey guys, take charlie's advice!

[PeteF]

I don't have a bearing press either but I usually manage with either the bench vice or some sort of lash-up with a bottle jack between two hard surfaces.