Forum

[Leon Novello]

I am having trouble fitting the spring into a Micarb; it probably is a simple job but I can`t remember how the cable and the spring are located. I know that the cable fits into the L-shaped slot at the side of the slide but not sure if it goes through the centre of the spring or on the outside.

[PeteF]

Through the centre.
It's sometimes easier to fit he cable then "wind" the spring on.

[Leon Novello]

Thank you Peter, that thought did enter my head after retrieving flying parts from around the shed floor.

[Norm]

Lepn, pull the twist grip off and remove the cable, then put the slide back together, so much easier

[Leon Novello]

Thanks Norm, I was beginning to think I needed three hands. I was starting to collect firewood to place underneath it when I go down to the pub.