Forum

[Nathan]

...from the headlight cowl of a crusader?
Just to add a potential difficulty, It was still attached when it was powder coated.

Advice would be appreciated. Cheers

Nathan.

[Nathan]

I can provide pictures if needed

[Mark M]

Tricky. I normally heat them locally then drift out. Why do you want to remove it, if it's reasonably sound, why not just clean it in position? REgards, Mark

[Nathan]

Well it was powder coated, I've rubbed it down, but I don't know what would be acceptable.
I was under the impression that it would potentially cause issues if it wasn't perfect.

[Nathan]

http://i1314.photobucket.com/albums/t56 ... e2aadc.jpg

http://i1314.photobucket.com/albums/t56 ... 6e7c36.jpg

What'd you reckon?

[Beezabryan]

That is shagged & so should the powdercoater be, with the rough end of a knobbly pineapple

[Nathan]

Yeah. I'll probably have it redone one day - for now I just want it running.

[Mark M]

I've got to say, that race looks ok to me but the pics are in Blurryvision (TM) ! If there are no obvious tracks or dimples I'd use it and see what it's like when assembled.
REgards, Mark

[Nathan]

Cheers. sounds good.

[Beezabryan]

That race looks like it has been sand blasted hence my comment. However I could be wrong but without actually seeing the article I would be loathe to change my opinion.