Forum

[gra]

Any body know where I can buy or borrow a crankshaft pot PED 2037

[Alan R]

Hello Matey--------- blimey, haven't seen one of those for yonks !! That's the circular, tapered support tool for the crankshaft to sit in while pressing takes place, I believe. It also has a slot where the con-rod goes. You could always get one fabricated using the sketch in the Bullet Workshop Manual as a guide ??

[gra]

thanks alan it was a long shot, i will have too see what i can come up with

[Beezabryan]

Any crankshaft work goes to professionals. Not expensive & saves a lot of ferking about

[Alan R]

--------yep, I would agree wholeheartedly with that sentiment. If you've never been involved with that sort of thing then, for a relatively small outlay of "wonga", get it done by those who do it for a living.