- Thu Jul 29, 2021 1:26 pm
#97844
Reading Stelam92's Topic on tuning his Electra X. i have done similar over the years, my bike has our hosts English made Exhaust pipe, small universal "silencer". Pod Filter. 19T gearbox sprocket.
Carb Jetting is 117.5. (std is !!0) and the needle maybe raised a notch (can't Remember).
My next stage is to fit larger carb, not sure what yet, but am thinking 32/34mm, the forums advice is most welcome. As covered on other posts on this forum, the inlet casting on the cylinder head is huge, masked by the inlet rubber assembly.
looking at the exhaust port, there is a crescent shape which i am looking to grind away to match the exhaust pipe . Would doing this spoil the port shape and exhaust gas flow?
Stelan92 115 Main Jet part number 112180/115
117.5 """"""""""""""""""""""""/1175
120""""""""""""""""""""""""""/120
Carb Jetting is 117.5. (std is !!0) and the needle maybe raised a notch (can't Remember).
My next stage is to fit larger carb, not sure what yet, but am thinking 32/34mm, the forums advice is most welcome. As covered on other posts on this forum, the inlet casting on the cylinder head is huge, masked by the inlet rubber assembly.
looking at the exhaust port, there is a crescent shape which i am looking to grind away to match the exhaust pipe . Would doing this spoil the port shape and exhaust gas flow?
Stelan92 115 Main Jet part number 112180/115
117.5 """"""""""""""""""""""""/1175
120""""""""""""""""""""""""""/120
Attachments
20210729_130545.jpg (1.29 MiB) Viewed 1420 times