- Tue Sep 10, 2019 12:08 pm
#85343
Hello All
I’ve just started to build a Bulsader (or Crullet if you prefer...) using Crusader cycle parts and Bullet engine & gearbox. I’ve just finished modifying the frame so it will be off to the powder coaters soon...
My questions concern the forks. There’s fractional play in the Crusader forks and I’m not yet sure if it’s wear in the alloy legs (no bushes!) or the stanchions. Does anyone know if Bullet stanchions will screw into the Crusader casquette and are they the right diameter for the lower yoke clamps? Are later Indian stanchions the same thread and diameter as the Redditch ones? Are they the same length as Crusader stanchions?
Thanks
I’ve just started to build a Bulsader (or Crullet if you prefer...) using Crusader cycle parts and Bullet engine & gearbox. I’ve just finished modifying the frame so it will be off to the powder coaters soon...
My questions concern the forks. There’s fractional play in the Crusader forks and I’m not yet sure if it’s wear in the alloy legs (no bushes!) or the stanchions. Does anyone know if Bullet stanchions will screw into the Crusader casquette and are they the right diameter for the lower yoke clamps? Are later Indian stanchions the same thread and diameter as the Redditch ones? Are they the same length as Crusader stanchions?
Thanks
Regards
Stephen
250 pre-unit Clipper
350 Indian Bullet Superstar
535 Bulsader
700 Conny
New 650 Interceptor
Stephen
250 pre-unit Clipper
350 Indian Bullet Superstar
535 Bulsader
700 Conny
New 650 Interceptor