- Fri Jun 02, 2017 1:30 pm
#67996
It is possibly a good idea to read the previous posts?. The actual thread has been cut a 1/4 inch short other than that is screws in OK.
Forum
For Royal Enfield owners and enthusiasts
- Mon Jun 05, 2017 10:16 am
#68074
Tracy tools don't sell a 1.3/8" 26tpi die anymore and to get one specially made was going to cost 150gbp...not very cost effective.. might have to have a rethink on what to do! (Can't find any other dies online)
- Mon Jun 05, 2017 10:41 am
#68076
A couple of 1/4" thick spacers seem would be the cheapest, if not the best option.
- Mon Jun 05, 2017 10:42 am
#68077
A couple of 1/4" thick spacers seem/would be the cheapest, if not the best option.
- Mon Jun 05, 2017 11:31 am
#68078
It should be possible to screw cut the extra length of thread on a lathe. It does take care but is it possible.
- Mon Jun 05, 2017 12:31 pm
#68079
Another option would be to see if another set of stanchions from a different source might be cost effective, though I would be considering whether losing 1/6th of the thread is enough to worry about if a set of 1/4" spacers can be sorted. A.
- Mon Jun 05, 2017 9:46 pm
#68095
Borrow a thread file with 26tpi and dress the staunchions up with that. If you can get someone to put them on a lathe that will make it easier.
Shop for accessories at Hitchcocks Motorcycles