Hitchcocks Forum

Crusader / Bullet trials bike project-
Mid 60’s Crusader frame bought from MrH (no V5)-
Continental GT swing arm- allows for fitment if 4.00 rear trials tyre-
New Bullet forks-
Ali top yoke with bar clamp and bolts-
Renthal trials bars-
2 Ali mudguards -
Complete Indian 500 engine in bits-
New Aluminium barrel-
Lightweight rockers-
The engine was running fine before I took it apart-
Mikarb carb-
Bullet pre-generator outer chaincase. (the narrow one for better tyre clearance)-
New aluminium wheel rims and SS spokes -
21“ front rim on refurbed Redditch ½ with huband new brake shoes -
18 “rear rim on re furbed full width hub-
2 wheel spindles and nuts-
Stainless steel rear wheel adjusters-
Trials folding foot rests-
Chain tensioner-
Lucas SR1 Mag rebuilt by ex Lucas technician-
re magnetised, re wound coil, new points and condenser-
Lucas ATD (needs modification to fit)-
It owes me £2250.00 as it stands-
Im in Bristol-






rebuilt insurance




aluminum chloride reactions

sorry should read - "Bullet pre-generator outer chaincase. (the narrow one for better ground clearance) "

Is it for sale .. i hope not ..

yes its for sale

Sorry to see you giving up on this one Mart, looks like all the hard work is done, apart from a bit of work on the cylinder fins to get the mag to fit.



May we ask why the change of plan?



A.

Hi Adrian - I don't have the time to finish it. thanks