Hitchcocks Forum

hi all


its my first time on this message board so be gentle with me


i have been building my indian 350 2004 bullet for about 3 years now (on and off )


ime trying to convert the hi beam /and indicator on the speedo dial to led hi beam is ok


but the indicator will only flash on one way the two wires that feed the old bulb is green and black  the other is black and white


if i connect the old bulb up this flashes normal


any help would be gratefully accepted


is the answer to fit two green led lights one for left and one for right


regards


vic

LEDs are polarized you will need two leds one each side in correct polarity.

hi paul many thanks


vic

 Vic,


      LED's give you problems, as said aboveI had to fit one for each side and also for some reason I had to wire in an extra bulb holder and run a standard globe in it , just laying inside the casquete to get one side to operate. I fitted the 6 led indicator lights on each side of the casquete because they are very bright and catch your attention, but at night they are so bright I can hardly see where I'm going when turning

help please


many thanks for your help paul mh  and norm


about green led indicator light in speedo


i found out that only one led is required as if you take the


two wires from flash unit to the pos and neg of led it works


ok opporsite of indicators thanks


i

breather pipe


hi all i have removed old air filter and housing bought an amal


26mm mono block what do i do with breather pipe from engine


and the one from black pot


regards vic