Page 1 of 1
What size thread?
Posted: Fri Dec 29, 2017 7:43 am
by Tomshayes
Hi.. Can anyone tell me what size bolt thread etc to fit the frame threaded hole in the photo? 2001 pre unit frame...
What size thread?
Posted: Fri Dec 29, 2017 9:19 am
by Leon Novello
That one fell out as I put the bike on eBay, a local engineering shop made one for $15 from the sample I gave him from the one on the other side of the bike.
What size thread?
Posted: Fri Dec 29, 2017 10:16 am
by Phil535
Hi on my 91 the thread is 1/2" CEI ( 26TPI )I don't know if they changed thread size as the years went on ..
Tom regarding your build , I am about to do mine the same ,
not wishing to clog up the forum I have a load of questions if you get time would you get in touch
[email protected]
What size thread?
Posted: Fri Dec 29, 2017 11:34 am
by stinkwheel
That's the bottom stud for the rear subframe yeah?
If so, the parts book online section on this website lists the nut that screws onto it (for a 2001 500 bullet) as "NUT, 1/2" SHOULDERED, REAR MUDGUARD CARRIER, BOTTOM".
http://www.hitchcocksmotorcycles.com/pa ... r_Mudguard
What size thread?
Posted: Fri Dec 29, 2017 11:37 am
by ed.lazda
My 2006 Bullet 350 still has the 1/2" cycle thread.
What size thread?
Posted: Fri Dec 29, 2017 12:17 pm
by Tomshayes
Thanks
Just wanted to order a couple of Stainless blanking bolts and washers!
REgards
Tom