Hitchcocks Forum

Hi again

Rusty's rockers are very worn. The bearing blocks have 'picked up' and as a consequence there's noticeable up-and-down movement at each end.

I presume this would result in a noisy top end and difficulty setting tappets...?

I'm thinking of going the Ally bearing set route, but MrH's are a little pricey. Having read the comment in the catalogue about quality, fit, 'O' rings etc I'm still uncertain and there are Indian ones available on line at half the price also fitted with 'O' rings.

Does anyone have any specific experience of these? (Aside from the general comment about Indian quality variability that is).

Thanks, Stephen

I've got Samrat rockers in 2 of my Bullets and not had any problems. (I won't say where I got them from!) I'm also soon going to be fitting them to the Ebay Bullet. It is simple enough to check/modify them but Samrat is actually quite a good brand quality-wise for Indian products.

REgards, Mark