Hitchcocks Forum

[center]




a "hammer and vice" production of 'Fixing the Centre Stand'

Two section post?











Tabellarius de verbis ostensor gaudium

An impressively neat "bodge" mate.

I enjoyed your video, what a neat well thought out modification.

Nice.

Nice job on the bequille centrale there, I'll treat my current proj to some of that. Fitting a grease nipple?. A.

Nice and neat !!

That is a good idea what size eyebolt is that looks like an M3

It's am M something, had to enlarge existing hole just slightly, ether a 5 or 5.5 mm drill, can't remember.



Ok, Ok, I know, but a little hard to get imperial stock in France, birthplaces of the metric system.

I could fit a grease nipple to the stand itself, to pump into the shaft.



I did start to drill into the end of the shaft, before I realised that it would only squeeze out of the split pin holes!