Page 1 of 1
Cylinder head torque settings
Posted: Sun Aug 02, 2015 9:48 pm
by Rob S
Hi everyone,Does anyone know the cykinder head torque settings for a 1962 Crusader Sports, I can't find anything in my workshop manual or on line, many thanks.
Rob
Cylinder head torque settings
Posted: Sun Aug 02, 2015 9:49 pm
by Rob S
That should be cylinder!! sorry thumbs for fingers!
Cylinder head torque settings
Posted: Mon Aug 03, 2015 7:20 am
by Mark M
22-23/ft lbs. Make sure the stud holes are clear by running a clearance drill through first to remove excess alloy. Also fit our Hosts hardened steel washers to prevent crushing in future. These are in the Bullet catalogue, you will have to phone them to get a set as they will be slightly different from the Bullet set. By the way, there is an information group just for the Crusaders at
https://groups.yahoo.com/neo/groups/Cru ... group/info where you will find a lot of friendly help and data in the Files section.
REgards, Mark
Cylinder head torque settings
Posted: Mon Aug 03, 2015 11:21 am
by PeteF
The quoted figure is with the threads dry. If they have oil/loctite on the figure will be a lot lower.
Cylinder head torque settings
Posted: Mon Aug 03, 2015 11:33 am
by Scalyback
WAAAAAAAHHH!
Every other bike had got it's own group or forum. I don't suppose there is a Meteor Minor one?
Cylinder head torque settings
Posted: Mon Aug 03, 2015 12:01 pm
by ric
22/23 dry would be 17 wet (lubed steel) according to an online conversion chart
Cylinder head torque settings
Posted: Mon Aug 03, 2015 9:28 pm
by Rob S
many thanks for your replies, I have ordered the washers and a few other bits and pieces I was needing.
Cheers
Rob