Hitchcocks Forum

I have been looking for a picture of an Electra X clutch, (with it still attached to the bike,) without any luck, can someone help please.

Hi Papa..I Thought an Expert would of Been on to Help you By know...BUT! I have Some Photo's of My AVL 350 (Think Electra 350) Clutch Problem Re-Build that I could E-Mail you if it Helps (No good with Sprag Clutch as 350 is K/S only But The Clutch Basket assembly should be the same) My Problem was that the Center Shaft Main Nut had Never been Fitted and 5 Years afterwards all Moved Left :0) No damaged done though..So 5 Speed AVL (Electra) 350 Photos available if of Use [ E-Mail craig.royalenfiald {Where ypu Put !) gmail.com. if you Know @ what I mean..Hope this Helps regards Craig

Craig, all I really want to know is what the clutch looks like, because I can't find a picture of one anywhere and also the clutch operating rod seems to be missing on every exploded drawing I can find. (I am going to fit our hosts operating rod end with thrust bearings, and the workshop manual is as much use as a chocolate fireguard.)
Thus far every spanner job I have carried out looks nothing like the manual, but in this case there is nothing in the manual.

Hi Papa When I sorted mine out I checked the Plates and Fitted a New Rod (Two Part) i think i put an extra ballbearing on the Rod and it worked a lot better (I took some photos all along the way,Just dont know how to post them here) all in all I just followed my instinct and found it an easy Job, and very mater of a fact to strip/rebuild etc..I did Not remove the Clutch Basket so No special Tools needed and "Once the Experts pointed out the Missing Nut" every thing worked out Ok...
I did fit the Improved Clutch Opp Arm at the same time,. :0)

Craig that is what is driving me nuts, I can find no picture/exploded view, list of parts for the clutch operating rod anywhere. When I spend out what is a lot of money for a workshop manual I really do expect such an important part to be shown in the manual somewhere. It isn't.

If it is the same edition as mine then section 5 pages 3 and 4 describes clutch disassembly with pictures showing the rod bearing assembly.

I Just used this as a guide.

http://www.hitchcocksmotorcycles.com/pa ... 298/Clutch
2005 Electra (X)
Page 14 - Clutch

Cheers Craig that did lead me to this the correct year for my bike:-

http://www.hitchcocksmotorcycles.com/pa ... 689/Clutch

Frank, there is no sign of that assembly at all in the manual I have.

Copy and paste this link in a browser windo and scroll down for the piccies, one of the guys on the French forum took some pictures while stripping his Electra's primary side.



http://www.royalenfieldlesite.fr/forum/ ... 33&t=10695



Hope this helps.



A.