Page 1 of 1
Drive sprocket for Chief/Apache
Posted: Wed Dec 03, 2014 11:23 pm
by Chief
Hi All,
I was wondering if would it be possible to replace the main sleeve in the Chief/Apache with one that is made to take the H49 sprocket? This would then give a choice of 20T, 21T, or 22T sprockets for my Chief.
Regards Charles
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 12:37 am
by Norm
Charles, don't forget I have a 22 here that I have just removed from the Meteor but that will depend on what engine sprocket the Chief is running. What does it have on it at the moment? I should have looked closer at the Apache one at the time but I was a bit rushed, needed to get the Super Apache up and running
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 1:38 am
by Chief
20T Norm.
Regards Charles
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 1:45 am
by Norm
Charles that is gearbox, what size is the engine sprocket?, quite possibly a 33 and if that is the case then 20 is all you need on the gearbox, it will struggle to pull any bigger and will run out of puff on hills. Your Inter has a 29 engine sprocket and that is why you can run a 22 on the gearbox
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 9:18 am
by Chief
My motor is late 1960, so it will either be the same as a Super Meteor or a Constellation, if they are different.
Cheers Charles
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 5:57 pm
by Norm
It should have a 29 tooth then Charles
Drive sprocket for Chief/Apache
Posted: Thu Dec 04, 2014 11:26 pm
by Norm
Charles, do you know if there is a parts book anywhere on the Chief gearbox, otherwise I think the only way you will be able to work it out is to either pull Dons box apart which will need rebuilding anyway or pull yours apart, either way no big deal
Drive sprocket for Chief/Apache
Posted: Fri Dec 05, 2014 5:30 am
by Chief
Phil might have one, I will ask.
Cheers Charles
Drive sprocket for Chief/Apache
Posted: Fri Dec 05, 2014 5:46 am
by Norm
Hadn't thought about Phil, he would probably know or have a mainshaft sleve you could check
Drive sprocket for Chief/Apache
Posted: Mon Dec 08, 2014 10:38 am
by Chief
Got this from the Inter site.
Regards Charles
G'day Charles,
I don't have any internals from an H-type Bullet or twin 'box to hand, but I seem to recall that the sleeve has 5 splines each end. The AM I had on the bench a few weeks ago had 6, both ends. If new sprockets are not available, I reckon you only have a few options: commission some, find a good used one, get an old sprocket retoothed, or fit a different 'box. The 'standard' Albion 4-speed 'box, with either pushrod or scissor clutch, as used on nearly all the other twins, will bolt straight in. If you do this, be prepared to address chain alignment and clearance issues if you are sticking with the fat 16" wheel and tyre.
Richard M