Page 1 of 1
CNC -through bits
Posted: Wed Oct 29, 2014 1:09 pm
by John R
Hmm,
could be amusing. Show off your Boyer ignition. On the other hand, I've got a sort of brass theme going on on my bike and that's what the tappet and points covers are. One day maybe
CNC -through bits
Posted: Thu Oct 30, 2014 3:12 pm
by Barry N
A see-through tappet cover would be nice! It would have a practical value apart from anything else, to see a re-assuring oil supply to the top end!
CNC -through bits
Posted: Thu Oct 30, 2014 9:53 pm
by John R
yes, one payday I expect I will impulsively click on it!
CNC -through bits
Posted: Sun Nov 02, 2014 9:49 am
by Norm
Barry I see they have see through tappet doors for the UCE and GT, not sure about the earlier Bullets
CNC -through bits
Posted: Sun Nov 02, 2014 10:39 am
by Nettshubby
Norm, I think the main problem with one for iron bullets is the central fixing stud, and stopping it breaking the plastic on tightening. I think they would have to have a metal piece in the middle to clamp up to the crankcase. Unless it was made of, say, 8mm thick Polycarbonate!
CNC -through bits
Posted: Sun Nov 02, 2014 11:24 am
by Beezabryan
Until I spotted the "news" thing I thought you guys had been partaking of illegal substances
CNC -through bits
Posted: Sun Nov 02, 2014 3:53 pm
by Barry N
Seems they do have them for the classic cast-iron engine. Type "see-thru" into the search box and you will see it!
CNC -through bits
Posted: Sun Nov 02, 2014 3:56 pm
by John R
Perhaps I should have pointed them out! You can get see through tappet covers for the iron barrels.
Logical next step is tappets with flashing LEDs and Boyer magnet rotors with a swirling spiral motif.
Now, pass me my herbal substances.