Page 1 of 1
Distance piece
Posted: Tue Aug 05, 2014 7:24 pm
by Norm
Does anybody know the width of the inner distance piece that goes between the 2 bearings on the drive side of a Bullet. I need to make one fairly quickly and the one I have is badly worn and I can't wait to get one from O/S. If nobody knows, does anybody know the thickness of one of the circlips that hold the drive side bearings in place. I can work it out if I know how thick they are. I can't believe I don't have any of these lying around here
Distance piece
Posted: Tue Aug 05, 2014 8:45 pm
by Alan R
Norm-------send an e-mail to the lads in Mr H's workshops--- they'll know, surely ??
Distance piece
Posted: Tue Aug 05, 2014 11:05 pm
by Norm
Thanks Alan, didn't want to bother Jo with something so simple but I guess I will have to
Distance piece
Posted: Wed Aug 06, 2014 3:00 pm
by Wayne
Hi,
Circlip - 1.94 mm
Inner spacer - 8.22 mm
Outer spacer - 5.63 mm
Hope this helps...
Distance piece
Posted: Wed Aug 06, 2014 4:45 pm
by zippy
Hi norm. which Bullet is this? my circlip 2.02mm / Outer spacer thickness 11.14mm / cant find the inner spacer...Engine is a'54 bullet
Distance piece
Posted: Wed Aug 06, 2014 7:43 pm
by Norm
Thanks Wayne and Zippy, all good Richard emailed me with the info, thanks again. Zippy it is for an early nineties Indian Bullet