Big End replacement
Posted: Fri Apr 06, 2012 7:59 pm
by Terry
Hi all I have just finished stripping down my Bullet sixty5 500 the big end bush has gone and ended up as fillings around the engine. the good news is there is no other damage. my next problem is getting the new crank pin pressed back into the fly wheels to complete the crank shaft rebuild. please can some tell me where to get this done. I live in Berkshire area. Thank You
Big End replacement
Posted: Fri Apr 06, 2012 8:15 pm
by Bullet Whisperer
Hi Terry,
I could do that for you, if all else fails, but you'd have to post it all to me [not next week though], I could then post it back all done if that's any use.
Regards,
Paul.
Big End replacement
Posted: Sat Apr 07, 2012 7:17 am
by Terry
That is good news depending on where you are I may be able to drop it in please let me know how much it will cost No rush to get it done I need to do a lot of cleaning parts. I will get all the parts from our host next pay day. So looking at getting it done about beginning of May. you can e-mail me your location and cost on this E-address
[email protected]
Thank You