- Thu Jul 18, 2013 4:52 pm
#2445
Help needed as I on a long trip on my 500cc classic Elec Start bullet and the bike is fine at speed in fact runs beautfully. But it cuts out coming to a halt at traffic lights or pulling in to a petrol station, unless the revs are maintained. It then will not start until it cools down - but will start with a new plug (champion N3c). We set the needle to the mid-point as it had been mistakenly set to lean, and the of the centre plug is grey and the outside is black - so almost right. The air screw is at one turn out rather than the recommended one and a quarter turns. It pops on the overrun very slightly, suggesting slight leanness. It has a new coil and condenser. Points are fine. Bike has 6000kms on it. Any thoughts on what might be causing this 'shut down and inability start' once it is hot? I have ordered new plugs from our hosts but they will take a couple of days to arrive in our remote location.