Page 1 of 1
clutch plates
Posted: Tue Jun 04, 2013 4:40 am
by Dean
confused by the discrepancy in the Snidal manual and hitchcocks tech notes. Snidel says the dished centers "reach towards the hub" (both dishes facing inward?) - hitchcocks says the inner dished plate raised surface should face the fitter (outward?) and the outer dished plate raised surface should face away from the fitter (inward?) (these would not face the same direction) which is right?
clutch plates
Posted: Tue Jun 04, 2013 5:25 am
by Norm
Dean, Hitchcocks are correct providing you have 2 dished plates, if you only have one it goes in as the outer steel plate and the dish faces in and when you fit it you will see why it is dished
clutch plates
Posted: Tue Jun 04, 2013 5:27 am
by scotty
Dean second option is correct 1st plate raised cenyre faces out other raised plate faces gearbox. good luck.
clutch plates
Posted: Tue Jun 04, 2013 5:28 am
by Phil Ashbrook
I'm inclined to go for hitchcocks tech notes as my last rebuild on the clutch did and everything is working just fine .