- Sat May 08, 2021 1:25 pm
#96666
Hi my electric start 2006 bullet wont turn over using the starter motor , ok on starting with the kick starter.
I have removed the motor and tested the motor and it works and runs with an external 12 vdc source.
My battery voltage is 12.6 vdc no load and and 12.14 vdc when start button pushed
The circuit is complete and all voltages and grounds correct to the motor supply cable when the start button is pushed are correct .
My question is how to you prove the sprag clutch is u/s , my pinion wheel 56014 spins freely in an anti clockwise direction and unable to turn freely clockwise., when looked from starter motor side.
Your help would be appreciated. Cheers ng
I have removed the motor and tested the motor and it works and runs with an external 12 vdc source.
My battery voltage is 12.6 vdc no load and and 12.14 vdc when start button pushed
The circuit is complete and all voltages and grounds correct to the motor supply cable when the start button is pushed are correct .
My question is how to you prove the sprag clutch is u/s , my pinion wheel 56014 spins freely in an anti clockwise direction and unable to turn freely clockwise., when looked from starter motor side.
Your help would be appreciated. Cheers ng