Hitchcocks Forum

Will a 3.50x19 block tread tyre fit the front wheel of a C5 standard mudguard? Mitas H02 I have in mind or similar, and can I assume a similar tyre 4.00x18 will fit the rear?

Can I suggest that the only certain way to be sure these tyres will fit is to get the overall measurement of the width of these two tyres [which may be very different from the 3.35 and 4.00 nominal width] and compare that with the available space in the width of the mudguards.

sir, if it helps i run hideneau 3.25x19 k34 on my 2015 c500 with maybe 1/2 to 1/4 inch of space between the tyre and mudguard so a 3.50x19 could be a tight squeeze , the 3.25x19 is perfect, looks great

Don't forget to check the gap between the front of the swinging arm too

I recently removed a 350x19 and a 400x19 from my bullet, not bad condition.
Free if you want them.
I'm in Torquay / Newton Abbott.
I hope our hosts don't mind !!

Black Fingernail,
I'll take you up on that offer I will be down that way in a week or two if you don't mind hanging on to them for awhile.
If you want to TXT me some details, I don't know if this site has a PM facility? If not I'll put my Mob No on here.

I don't think there is a pm facility at the moment

If you want to give me a number I'll give you a call

Blackfingernail. Are you a member of the MBR forum? I'm a bit reluctant to post phone No on here after the last episode of doing so. If you are on MBR you can PM me under the the same name. RoSy.

I am a member of the unofficial Royal Enfield community forum, you could pm me there. Same username.
I am not on the MBR forum.