- Fri May 08, 2020 11:42 am
#89862
I've just fitted a pair of Motone tank pads. They went on ok except for a 1 inch gap along the top edge on one side.
I've tried holding it down but it doesn't want to take, even though the tank was FULLY degreaser.
I'm thinking of using a drop of some sort of glue to seal it and keep water out, to avoid a rust trap on a relatively new machine.
Any ideas, comments or suggestions would be most gratefully received.
I've tried holding it down but it doesn't want to take, even though the tank was FULLY degreaser.
I'm thinking of using a drop of some sort of glue to seal it and keep water out, to avoid a rust trap on a relatively new machine.
Any ideas, comments or suggestions would be most gratefully received.