Hitchcocks Forum

I fitted a Givi screen to my 500 efi Bullet but I have a problem. I can turn the key just, but it is putting a lot of pressure on the ignition switch

Not familiar with the Givi screen but can you swap the mounts left and right so they are behind the bars
Difficult without seeing it Dai

Unfortunately they don't fit the other way either.

Only way I can see to do it is to cut the black section
Hopefully someone else will have a better idea

Take care Dai
Edit

Still not much room there must be a better way

If you bought it specifically for this bike I'd sent it back; it's not fit for purpose. Other screens fit ok.

Made a new bracket, so it clears the key (just). Supplied bracket top, my bracket bottom.

would it work if you swapped the brackets over? ie move the left bracket in your picture to the right side and vice versa.