Forum

[McMurdo]

Just a shout for this eBay seller who is making stainless rear wheel adjusters for the Bullet. Very nice quality and has a slot so that you can use a 1/4" drive to adjust. I put a pair on Bertie and they make the rest look shabby

https://www.ebay.co.uk/itm/Royal-Enfiel ... 2749.l2649

[Wheaters]

Lovely stuff, thanks for posting this.

Obviously, I couldn't resist.....

[Daiwiskers]

Sold out!
You should be on commission
Nice find Dai

[McMurdo]

If you contact him he may have another batch in production

[McMurdo]

I think he just posted a new listing …


https://www.ebay.co.uk/itm/Royal-Enfiel ... SwOVpXejD4

[Daiwiskers]

Well I bought those one's
He must be wondering what's going on

Cheer's for the tip off Dai

[Boxerman]

I bought a pair of those what must have been a couple of years ago, good to see he's still selling them.
I had to fit them with the numbers on the inside as the chain is on the oposite side on the EFI models. I memntioned this to the seller and see that he now comments about it in his description.

Frank

[PeteF]

Nicely made by the look of them but just be aware that a lot of earlier Bullet frames were by no means acurately made.
If you set up these cams correctly the wheel still isn't necessarily square in the frame.
You can check wheel allignment with a long plank or a laser but I find the easiest way is to have someone follow you. It's obvious if the wheel's not straight.

[Rushour]

All well and good but the snail cams are still a crap idea - and our hosts improvements are on all my bikes : https://accessories.hitchcocksmotorcycl ... ters/19190