Forum

[73a]

hi i was under the impression from an early post you could convert a scissor operation redditch gearbox main shaft with an indian main shaft for push rod operation , i have a redditch 1958 minor gearbox going in a 1983 bullet.
i have come accross only one issue the small end bearing redditch h6 is too tight for the indian shaft ?

[Bullet Whisperer]

Mainshafts for the twins are a bit longer than those for singles.

[vince]

Mainshaft will need to be machined to fit bearing, also you will outer case with clutch lever which is not present on scissor clutch gearbox. Vince

[73a]

i have sorted out a bearing via a our hosts , i will have the case machined to suit nke 6303 bearing . my outer case is from an indian bullet and has fulcrum arm. thanks ng

[vince]

Hi, try and get find of an indian inner case which will save machining . Vince