Page 3 of 3

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Tue Oct 15, 2019 9:56 pm
by Daiwiskers
Is that the one by the spark plug? that was the one that was stripped in the crankcase on mine Redditch engine, it felt like it was tightening up but was infact tightening against the bottom of the barrel
Hopefully yours is not the same
Cheers Dai

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Wed Oct 16, 2019 1:07 pm
by Allanfox
Hope not!!! The thread feels ok but will find out when finally tightening, just waiting for new nuts to finish the job, can't pretend i don't have a bad feeling about it!!! :-(

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Wed Oct 16, 2019 1:45 pm
by stinkwheel
Worth mentioning that when I fitted the hitchcocks studs to my bullet, I had to run a tap down the crankcase holes because they weren't cut deep enough at the factory.

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Fri Oct 18, 2019 7:36 am
by Allanfox
Now that makes sense! :-)

Car security camera

Posted: Sat Oct 19, 2019 3:41 am
by joereitman
Car security camera are generally used in security checkpoints for under vehicle checking, and also used in rescue works for human life detection. With the help of the retractable rod and the supplimentary infrared light, the user could get the clear view of the blind corners, and detect human life within 8 meters. It's a quite cost-efficient equipment for security inspection and human life detection.

******* THIS IS A SPAM POSTING! IT HASN'T BEEN DELETED AS THE SUBSEQUENT POSTINGS WOULDN'T HAVE MADE SENSE - graeme @ hitchcocks *******

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Sat Oct 19, 2019 8:00 am
by Wheaters
Now that DOESN’T make sense. :roll:

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Sat Oct 19, 2019 9:03 am
by Daiwiskers
I think we're getting spammed

Re: Replacing head gasket 350 kickstart, 4 speed

Posted: Sat Nov 09, 2019 2:16 pm
by windmill john
Bloody spammers!

Anyway, today as I discovered my right hand head bolt was not tight, I took off the rockers and discovered that the four ‘hidden’ head bolts were.... loose.

I say loose, that might be an exaggeration, but not far, I’m surprised it ran!

Anyway, those four torqued correctly, but the tight hand side one.... just turns....

No worries, come the better weather, I’ll helicoil it.

John