Forum

[Graham43]

Hi.
Just stripped down head and cylinder to work on tappets. The cylinder bore seems good with only very light vertical marks. I did notice the bottom oil scrapper ring (?) seems to be in separate parts, is this correct. On my old BSA A10 it was in one piece, two thin rings separated by a corrugated spacer, but on my Electra the bottom thin scrapper ring is loose, is this correct? Also is it a good idea to renew all the rings whilst I have the head of?

[PeteF]

Yes, separate rings.

[Graham43]

Thanks PeteF, if I had taken the trouble of looking at the parts list I would have found the answer. Thanks again for your help.

[papasmurf]

Sorry to be a pedant but it is scraper ring not scrapper ring.

[Bullet Whisperer]

If the ring gap is excessive, it could well be a 'scrapper' ring. Ho, ho ho, merry Christmas etc. Regards, Paul.

[Beezabryan]

But if it ain't it ain't innit