Forum

[jimbo]

Hi, I wonder if any one could help me with a little wiring problem, I have with a second hand Boyer Micro-mk-1V That I have just purchased? Can you tell me how to wire it up correctly? I have a 2006 500 Bullet with electric start. I did manage to get a good spark from the plug but the engine would not fire. I think I have messed up with the wiring to the coil. there was a blue wire that had been cut short, could this be the problem? do I remove all the existing wires from the coil? Any help would be much appreciated. Thanks a lot jim

[Alan (Lancashire)]

copy and paste this link ,,,,,,,,,,,,, http://www.boyerbransden.com/pdf/KIT000 ... 00160_.pdf ,,,,,,,,,,,,,,,


you should be able to print this , or save the file to your computer.

hope this helps

alan

[Alan (Lancashire)]

sorry try this one ,,,,,,,,,,,,,,,,,,,,,,, http://www.boyerbransden.com/pdf/KIT000 ... 00160_.pdf

[Alan (Lancashire)]

pay attention that you connect the "trigger" wires the correct way , or the boyer will fire something like 60 degrees out!

[Midge]

This might help.

[Norm]

You have to keep the I think from memory red/black to the coil. The diagram Midge put up shows red/white but I think that is an old diagram, the red/black comes from the kill switch and even though it will run with this wire removed it will disable the kill switch. Some might say this is a good idea